Categories
Linux News PC Reviews Technology

PoE USB Hub HAT for Raspberry Pi Zero

Reading Time: 2 minutes

The PoE USB HUB HAT for Raspberry Pi is a double-decker board that features an Ethernet port and fully isolated SMPS (Switch Mode Power Supply) on the bottom board, with a second board stacked on top holding the three USB ports. Coming already assembled, the two boards are held together by hex pillars.

Extra pillars and screws are supplied to mount your Raspberry Pi Zero on the top – maybe this should be called a HAB (Hardware Attached on Bottom) rather than a HAT!
PoE USB

Power over Ethernet for Raspberry Pi Zero

The USB board has four pogo pins that connect to test pads on the underside of Raspberry Pi Zero, so you need to ensure it’s mounted tightly and accurately to make solid connections.

An obvious advantage of mounting the HAT underneath Raspberry Pi Zero is that it leaves the latter’s GPIO header free to connect other boards or electronic components.

One caveat is that you’ll need an 802.3af compatible router for Power over Ethernet to work. If not, you could always add a PoE switch or injector between the router and HAT. With an input voltage of 37 to 57 V DC and output of 5 V 2 A, up to around 13 W of power can be supplied, which should be plenty for most uses. Alternatively, if you don’t need PoE, you could simply power Raspberry Pi Zero normally via micro USB, which will in turn power the HAT.

While we’ve seen DIY solutions for adding PoE or standard Ethernet connectivity to Raspberry Pi Zero, and USB ports via a hub, this HAT offers a neat all-in-one solution. 

  • Power over Ethernet: IEEE 802.3af-compliant PoE, 37 V ~ 57 V DC input, 5 V 2 A output

  • Connectivity: 10M/100M RJ45 Ethernet port, 3 × USB-A ports

  • Dimensions:23.1 × 65 mm

PoE USB HAT for Raspberry Pi Zero verdict

Adds both PoE and extra USB ports to Raspberry Pi Zero without using the GPIO header.
8/10

Facebook Comments

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.